Filter
Top Products
EtherHub 1500 System User’s Guide
Setup and Configuration 4-17
• A "short press" is used to switch between the selections
available within each function. For example, in Segment
Setting, there are 4 selections available. By using a "short
press" on the
Configure button, you can move from one
selection (e.g., Attach hub to Segment 1) to the next (e.g.,
Attach hub to Segment 2). Note, however, that a selection will
only take effect after a "long press" on the
Configure button.
• If the button is not pressed within 10 seconds, the system
returns to normal operation effecting all changes made prior
to selecting the current function.
To summarize,
1. Access configuration functions by using a "long press".
LEDs light up to indicate the current configuration function.
(Example: Hub ID LEDs will display a combination of
BLINKING/OFF lights to indicate that the system is in Hub
ID Setting mode.)
2. Compare the LED display you see on the hub’s front panel
with the appropriate LED display in the succeeding pages.
Each LED display corresponds to a selection within a
function. (Example: If the system is in Segment Setting
function, see the LED display table under
Segment Setting
Function
in this chapter).
3. If you want to implement the selection displayed for your hub,
proceed to step 4. Otherwise, move to the next selection
using a "short press". Repeat a "short press" until you find
the selection you want.
4. To implement your selection and continue on to the next
function, use a "long press".