Filter
Top Products
EtherHub 1500 System User’s Guide
4-6 Setup and Configuration
Activate the EtherHub 1500 System Configuration Program
from a local console or via modem connection as described
below. This will open the communication dialog box shown
in
Figure 4.1.
From a local console -
Type “
EH15SCP” at the DOS prompt C:\>EH15SCP
From a remote modem connection -
• When using a PCMCIA FAX/Modem, first add the
following entry to your
config.sys file:
device=cardtalk.sys /A /Com3IRQ=4
• If your PC has a PCMCIA Fax/Modem or multi-I/O card, set
the proper IRQ by typing “
EH15SCP/i [irq #]”. Help is
available by entering “
EH15SCP/?”.
To activate a selection press the
keyboard character corresponding to
the highlighted character on screen.
Or, use the arrow keys to move to the
selection and press [Enter].
Figure 4.1 Communication Port Dialog Box
3. Using arrow keys, select the workstation’s communication
port connected to the EtherHub-16mi
+
. The DCE/DTE
dialog box will appear as shown in
Figure 4.2.