Filter
Top Products
Troubleshooting 4-21
Other Functions Failure 0
HDD Not Operating Correctly 0
If the HDD fails to operate correctly, perform the following, one at a time.
1. Disconnect all external devices.
2. Run a complete virus scan using up-to-date software to confirm the computer is virus free.
3. Run the Windows Vista Startup Repair Utility:
a. Insert the Windows 7 Operating System DVD in the ODD and restart the
computer.
b. When the Install Windows screen appears, click Next.
c. Select Repair your computer.
d. When the System Recovery Options screen appears, click Next.
e. Select the appropriate operating system, and click Next.
NOTE:
NOTE:
Click Load Drivers if controller drives are required.
f. Select Startup Repair.
NOTE:
NOTE:
Startup Repair attempts to locate and resolve issues with the computer.
g. When complete, click Finish.
If an issue is discovered, follow the on-screen information to resolve the problem.
1. Run the Windows Memory Diagnostic Tool. For more information see Windows Help and
Support.
2. Restart the computer and press F2 to enter the BIOS Utility. Check the BIOS settings are
correct and that CD/DVD drive is set as the first boot device on the Boot menu.
3. Confirm all cables and jumpers on the HDD and ODD are set correctly.
4. Remove any recently added hardware and associated software.
5. Run the Windows Disk Defragmenter. For more information see Windows Help and
Support.
6. Run Windows Check Disk by entering chkdsk /r from a command prompt. For more
information see Windows Help and Support.
7. Restore system and file settings from a known good date using System Restore.
8. If the issue is not fixed, repeat the preceding steps and select an earlier time and date.
9. Replace the HDD. (Refer to Maintenance Flowchart)