Filter
Top Products
Selecting a Configuration Model PRELIMINARY
34 Megabit Modem 500L Installation Manual
PR
EL
I
M
I
N
A
RY
SELECTING A CONFIGURATION MODEL
There are many configuration options for the Megabit Modem 500L from which you can select.
Select the following options are recommended for enhanced performance:
• DHCP not selected to allow the user to manually enter an IP address to the PC
• NAT to map the public IP addresses (proxy IP addresses) acquired from the service
provider to the PC IP address
The following matrix shows the recommended configuration:
The following is a recommended procedure for configuring the Megabit Modem 500L:
1 Complete the WAN configuration (page 36). It is optional to map a LAN user to each PPP
over ATM session at this time. You can perform this at a later time (see Step 4) after the
modem dynamically serves IP addresses to LAN users or you have manually assigned IP
addresses to LAN users.
2 On the EasySession page:
a Select the session you want active then click
Enable. The modem sets up the session
with the service provider. The
Up radio button next to the session(s) will indicate that
the session was successfully set up.
b When dynamically acquiring an IP address from the service provider, the session
receives the IP address at this time.
3 Set up the LAN side configuration (page 39).
4 Map the IP address for the PC to a session (page 38).
DHCP NAT
How WAN IP Address
Acquired
On On Fixed