Filter
Top Products
Saving the Configuration PRELIMINARY
42 Megabit Modem 500L Installation Manual
PR
EL
I
M
I
N
A
RY
2 Click Add to accept the Static NAT Entry.
3 Repeat Step 1 and Step 2 to add up to 32 static NAT entries.
4 To delete a
Static NAT Entry, highlight the entry in field then click Delete.
5 Click
Done to return to the PPP over ATM LAN Configuration page.
SAVING THE CONFIGURATION
Although you have submitted new settings, the parameters are not permanent until you write
them to NVRAM. See “Saving the Configuration” on page 21 to save the WAN and LAN
configurations to NVRAM.
Enter the Remote IP Address for a user at a remote site that you are mapping to a user
on the LAN (LAN user was entered in field
of the Static NAT Entry shown above).
Port is the logical port for the protocol (UDP or TCP) you select for this NAT entry.
Your system administrator will provide the protocol port number.
If you do not have the information for the remote user and port, enter 0.0.0.0 for the
Remote IP Address and/or 0 for the Port Address.
Select a Protocol (UDP or TCP) for the transport used between the LAN and the
remote user for this static NAT entry. (See “NAT” on page 57 for more information
about the transport protocols.)
This field lists the IP Address, Port, and Protocol for the Private, Proxy and Remote
fields defined. You can have up to 32 static entries.