Filter
Top Products
PRELIMINARY Chapter 6: Configuring Sessions
Megabit Modem 500L Installation Manual 41
PR
EL
I
M
I
N
A
RY
Defining Static NAT Entries
Static NAT entries are required only for applications that use TCP/UDP connections initiated
from the remote end (WAN). Through the
Static NAT Table, you can map inbound traffic from a
remote user to a user on your LAN. You can enter a maximum of 32 static NAT entries.
1 Do the following to map static NAT entries:
Enter the Private IP Address for a user on the LAN that is mapped to the
Proxy IP Address you will enter in field
of the Static NAT Entry shown below.
Port is the logical port for the protocol (UDP or TCP) you select for this NAT entry.
Your system administrator will provide the protocol port number.
Enter the Proxy IP Address which is the IP address assigned to a particular session by
the service provider (see the
field on page 36 for where to find the proxy
IP address).
Port is the logical port for the protocol (UDP or TCP) you select for this
NAT entry
. Your system administrator will provide the protocol port number.