Filter
Top Products
Configuring PPP over ATM Sessions PRELIMINARY
40 Megabit Modem 500L Installation Manual
PR
EL
I
M
I
N
A
RY
4 Click Submit after completing the LAN configuration page.
5 After changing a LAN IP address and subnet mask (or changing the IP address and subnet
mask), effect the configuration by completing the procedures for “Saving the
Configuration” on page 21.
The modem automatically assigns the Start IP Address for the first device on the LAN
as one address higher than the Ethernet port on the modem, when DHCP is enabled.
You cannot edit this field.
Enter the IP address for a device that will be the Primary DNS. The primary Domain
Name System (DNS) device translates human-readable machine names into IP
addresses. (See page 59 for more information on DNS resolution.)
Enter the IP address for a device that will be the Secondary DNS. The DNS device
translates human-readable machine names into IP addresses. (See page 59 for more
information on DNS resolution.)
The modem automatically enters the Gateway IP address which is the same
IP address as the LAN (Ethernet) 10/100BASE-T port of the modem. You cannot
edit this field.
Click Static NAT Table to open a dialog in which you can map inbound Internet traffic
to specific sessions. Go to the section on “Defining Static NAT Entries” on page 41
to configure these parameters. Configuring Static NAT entries is optional.