Filter
Top Products
SmartView XPro Installation and Use Page 44
name and password to access the SmartView.
4.8 Keyboard hotkeys
SmartView XPro can be conveniently controlled using special keyboard hotkey
combinations. These hotkey combinations can be used to select computers and
perform a number of other useful functions. All of the hotkey control commands are
invoked by holding down the hotkeys and then pressing a command key. By default,
the two hotkeys are ‘CTRL’ and ‘ALT’, although other combinations can be selected
by reconfiguring the hotkeys (see section 3.6.3). Once the hotkey command has
been activated you will need to release the hotkeys and the command key before a
new hotkey command is accepted by the SmartView. HOTKEYs + TAB is an
exception and this allows you to 'tab through' the ports by holding down the hotkeys
and repeatedly pressing TAB. HOTKEYs + the cursor keys is also an exception. You
can hold down the hotkeys and repeatedly press the cursor keys to change the
position of the on-screen menu.
The hotkey commands are summarised below (note that the numbers on the
numeric keypad do not form part of a valid hotkey). The hotkeys will only select the
requested channels if you have access rights to the requested channel.
Selecting computers using the hotkeys and the port number is most suitable for
systems with small numbers of computers. For systems with more computers it is
easier to use the on-screen menu for computer selection.