Filter
Top Products
8 64179008APL1-5A
Connections
WARNING
Risk of electric shock. Voltages up to 190 VDC
may be present on telecommunications circuit.
Always ensure that the frame ground is connected
to the lug inside the OSP housing.
All subscriber loop and network connections are made
through termination blocks. Refer to Figure 4.
Connections for the commons and access modules are
made through the backplane. No additional backplane
wiring is necessary for operation.
UL Deployment Guidelines
• Terminate enclosure to a reliable ground source.
• This unit shall be installed in accordance with the
requirements of NEC NFPA 70.
ADSL and POTS Connection
One 25-pair termination block provides the
interconnect wiring for the access modules located in
slots 1 through 6 of the enclosure. When using the
Quad ADSL plus POTS Access Module, the POTS
signal is provided by the network and is connected to
certain pairs on the Total Access 1000 DAT
termination block. The ADSL plus POTS signal is
then delivered to the customer by other pairs on the
termination block. See Table 2 for pair assignments.
Table 2. Termination Block Pin Assignments
riaPepyTnoitcennoCremotsuCotTUO/krowteNmorfNI
sseccA
eludoM
troP
1STOPNI11
2STOPsulpLSDATUO11
3STOPNI12
4STOPsulpLSDATUO12
5STOPNI13
6STOPsulpLSDATUO13
7STOPNI14
8STOPsulpLSDATUO14
9STOPNI31
01STOPsulpLSDATUO31
11STOPNI32
21STOPsulpLSDATUO32
31STOPNI33
41STOPsulpLSDATUO33
51STOPNI34
61STOPsulpLSDATUO34
71STOPNI51
81STOPsulpLSDATUO51
91STOPNI52
02STOPsulpLSDATUO52
12STOPNI53
22STOPsulpLSDATUO53
32STOPNI54
42STOPsulpLSDATUO54