Filter
Top Products
Operation and Maintenance Manual 45
Step 2: Unpack and Inspect the Instrument
Before unpacking boxes, inspect them for signs of physical damage. If damage
is observed, photographs should be taken in order to make a claim with the
carrier should any equipment damage be found. Check contents of boxes
against the shipping documents. Contact Agilent as soon as possible should a
discrepancy be found.
Required Installation Tools
The following tools are recommended for installation of both the 355 SCD and
255 NCD:
• One adjustable wrench, with adjustment up to 1 inch (2.5 cm)
• One 1/4"-5/16" open-end wrench
• Two 3/8"-7/16" open-end wrenches
• Two 3/4"-9/16" open-end wrenches
• One 5/8" open-end wrench
• One 1/4" Nutdriver with hollow shaft (for FID restrictor)
• One Phillips head screwdriver
• One pair cotton gloves (for hand protection)
• One small flat-head screwdriver