Filter
Top Products
56 Operation and Maintenance Manual
Step 4: Connect the Power Cord
Connect the pump power cord to the female socket on the back of the Detector
(see Figure 17). The pump has an On/Off switch located on the electrical motor
and this switch should be turned On. Do not connect to the AC power supply at
this point in the installation procedure.
Figure 17 SCD (230 V Unit) Rear Panel Diagram
AIR INLET
RECORDER
OUTPUT
FUSE 250 VOLTS
10 AMPS
VACUUM
PUMP
EXHAUST
10V
1V
100mV
Voltage Label