Filter
Top Products
Operation
Symmetra PX 10-40 kW 208 V Operation & Maintenance Guide - 990-4104B 15
Quick configuration
You must configure three TCP/IP settings before the Management Card can operate on a network:
• IP address
• Subnet mask
• Default Gateway
From the PowerView Display:
Network Cable not supplied with unit.
Disregard the procedures in this section if you have an APC InfrastruXure Manager as
part of your system. See the InfraStruXure Manager’s documentation for more
information.
If a Default Gateway is unavailable, use the IP address of a computer located on the same subnet
as the
Management Card that is usually running. The Management Card uses the Default
Gateway to test the network when traffic is very light. See “Watchdog Features” in the
“Introduction” of the Network Management Card User’s Guide CD (.\doc\usrguide.pdf) for
more information about the watchdog role of the Default Gateway. The Management Card
User’s Guide CD is located in the documentation storage tray.
Control
Status
Setup
Accessories
Logging
Display
Diags
Help
Top-Level Menu
View Network Setup
Accessories Menu
IP>>159.215.086.082
Network Set-up Screen
Accept changes
Network Set-up Screen
Mask>>255.255.255.000
Gway>>159.215.086.001
Web/SNMP Mngmnt Card
Network Setup
IP>>159.215.086
Accept changes
Mask>>255.255.255.000
Gway>>159.215.086.001