AMX none Network Card User Manual


 
WAVE 2
-Way Wireless Accessories and Adapters for Touch Panels Installation 27
WAV-PK Battery Replacement
Replace the WAV-PK battery (Figure 29) as follows.
Battery
Battery clip
Wake-up button
Battery cover
Power supply
connector
ON
Battery cover
release tab
Battery
compartment
1. Remove the battery cover by pressing outward on each of the battery cover re-
lease tabs while lifting upward and backward at the same time.
2. Grasp the battery and lift it from the battery compartment. Then, pull the bat-
tery clip from the battery.
3. Install a charged battery by performing steps 2 and 1 in reverse.
Figure 29
WAV-
PK battery removal
Note
The WAV-PK or WAV-PKM
battery must be charged for a
minimum of 4-hours before
use.
Caution
Keep the following important
safety considerations in mind
when using the WAV-BP and
WAV-BPM batteries:
Do not incinerate.
Do not directly connect the
negative and positive ter-
minals.
Do not use with battery
chargers other than the
WAV-PK and WAV-PKM.
Warning
Do not drop or subject the bat-
tery to strong physical shock.
Do not use battery to power
equipment other than the
WAV-PK or WAV-PKM.
Do not use the battery below -
10°C (15°F) or above +40°C
(105°F) If the temperature ex-
ceeds this upper limit, a safety
device automatically prevents
operation of the battery.