Filter
Top Products
access-list name <WORD> set l4port DST-port
This command specifies the destination TCP/UDP port range.
Format access-list name <WORD> set l4port DST-port from <1-65535> to
<1-65535>
Mode Global Config
4) access-list name <WORD> set IP-mode packet-type
This command specifies the packet type.
Format access-list name <WORD> set IP-mode packet-type
{ICMP|IGMP|IP|TCP|UDP|GRE}
Mode Global Config
5) access-list name <WORD> set mac-mode
Specify ACL entry priority.
access-list name <WORD> set mac-mode mac SA
This command specifies a source mac address.
Format Access-list name <WORD> set mac-mode mac SA <mac-addr>
<mask-addr>
Mode Global Config
access-list name <WORD> set mac-mode mac DA
This command specifies a destination mac address.
Format access-list name <WORD> set mac-mode mac DA <mac-addr>
<mask-addr>
Mode Global Config
access-list name <WORD> set mac-mode ether-type
This command specifies the ether type of the packet.
Format access-list name <WORD> set mac-mode ether-type
{ipv4|ARP|xns}
Mode Global Config
10.4.24 arp Commands
Note: This commands only support on GG24 GIGABIT PORTS WITH 2
SHARED MINI-GBIC SLOTS/G44 GIGABIT PORTS WITH 4 SHARED
MINI-GBIC SLOTS L2 MANAGEMENT SWITCH)
10.4.24.1 arp dynamic
1) arp dynamic enables and disables.
This command enables and disables dynamic arp functions.
Format arp dynamic {enable|disable}
Mode Global Config
2) arp dynamic aging-time
This command set arp dynamic aging-time between 0s and 999s.”0”means
42
disable.
Format arp dynamic aging-time <0~999>
Mode Global Config
3) arp dynamic ports
This command set dynamic arp ports to trust and un-trust.
Format arp dynamic ports {trust|untrust} <port-list>
Mode Global Config
e.g. Swtich<Config># arp dynamic ports trust 1-4
Swtich<Config># arp dynamic ports untrust 4
4) arp dynamic vlan
This Command set add/remove dynamic arp on specified vlan.
Format arp dynamic vlan {add|remove} from < vlan -id> to < vlan -id>
Mode Global Config
e.g. Swtich<Config># arp dynamic vlan add from 1 to 1
Swtich<Config># arp dynamic vlan remove from 1 to 1
10.4.24.2 arp static command
This command set arp static address table for mac address with IP Address.
132 Asante IntraCore IC39240/480 User’s Manual