Filter
Top Products
log Configure log server
radius-server Configure radius server
static-address Static address
mgmt-accesslist Set management access list, allows up to 8 IP addresses
monitor Configure port mirroring
dot1x Configure 802.1x parameters
network Configuration for inband connectivity
port-all Configure all switch ports
qos Configure QoS
rmon Configure Remote Monitoring
set Configure IGMP and static multicast
snmp Configure SNMP parameters
sntp Configure SNTP
https Configure SSL
spanning-tree Configure spanning-tree
tacplus Configure tacacs+
user Change user password
interface Enter into configure interface mode
green-eth Configure Green Ethernet enable or disable
Switch(Config)#
From global configuration mode, you can access three additional configuration modes: Use the interface command
to access its configuration modes.
4.3.1 Interface Configuration Mode
Many features are enabled on a per-interface basis. Interface configuration commands modify the operation of an
interface such as an Ethernet or serial port. Interface configuration commands always follow an interface global
configuration command, which defines the interface type as Ethernet.
In the following example shows configuration of Ethernet interface 1. The new prompt, Switch(interface 1)#,
indicates the interface configuration mode. In this example, the user asks for help by requesting a list of commands.
28 Asante IntraCore IC39240/480 User’s Manual