Filter
Top Products
e.g. switch(interface g1)#lacp admin 36768
10.5.3.2 priority command
Configure lacp port priority
Format lacp priority <0..65535>
Mode Interface Config
10.5.4 addport command
add one port to a LAG group
Format addport <LAG-ID>
Mode Interface Config
10.5.5 delport command
Remove a port from a LAG group
Format delport <LAG-ID>
Mode Interface Config
10.5.6 lldp command
An lldp agent can transmit information about the capabilities and current status
of the system associated with its MSAP identifier. The lldp agent can also
receive information about the capabilities and current status of the system
44
associated with a remote MSAP identifier. However, lldp agents are not
provided any means of soliciting information from other lldp agents via this
protocol.
10.5.6.1 lldp state set
lldp status
Only transmit the lldp status
Format lldp state {tx|rx| tx_rx|disable}
Mode Interface Config
10.5.6.2 configure notifications
Enable/disable notification form the agent
Format lldp notification {enable|disable}
Mode Interface Config
10.5.6.3 Configure med notifications
Configure wether or not MED notifications from the agent are enabled.
Enable/disable med notification form the agent
Format lldp med-notification {enable|disable}
Mode Interface Config
e.g. Switch(Interface 1)#lldp med-notification enable
10.5.6.4 Configures which TLVs are enabled for
transmission.
1) basic set
Format lldp tlvs-tx {enable|disable} option basic
{port-desc|sys-name|sys-desc|sys-capa|sys-capa }
Mode Interface Config
2) 8021 set
Status of local-802.1 settings
Format lldp tlvs-tx {enable|disable} option 8021 {pvid| vlanname|
protocol-id}
Mode Interface Config
eg.switch(interdface 1)lldp tlvs enable option 8021 pvid
3) 8023 set
Format lldp tlvs-tx {enable|disable} option 8023 {mac-phy| power|
link-aggregation| frame-size}
Mode Interface Config
4) MED-set
Status of MED Settings
Format lldp tlvs-tx {enable|disable} option med-set {capabilites| net-policy|
location-id| mdi}
134 Asante IntraCore IC39240/480 User’s Manual