Filter
Top Products
Configuring Switch/Bridge Priority
For <priority> the range is 0 to 61440 in increments of 4096; the default is 32768. The lower number is used when
you want to specify the switch as the root switch.
Valid priority values are 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056, 49152,
53248, 57344, and 61440. All other values are rejected.
Command Purpose
spanning-tree priority 8192
Set switch priority to 8192
Configuring Link Type
Use the following interface mode command to configure port link-type:
Command Purpose
spanning-tree port force-p2plink enable ports 1-2
Set link type of port 1,2 to point to point
By default, the link type is determined from the duplex mode of the interface: a full-duplex port is considered to have a
point-to-point connection; a half-duplex port is considered to have a shared connection.
To return the switch to its default setting, use the following configuration command.
Command Purpose
spanning-tree port force-p2plink auto ports 1-2
Set link type of port 1,2 to auto
Configuring an Edge Port
Use the following interface mode command to configure port link type:
Command Purpose
spanning-tree port edge enable ports 1-2
Set port 1,2 to edge port
43 Asante IntraCore IC39240/480 User’s Manual