Filter
Top Products
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-22-2
2-22-2
2-2
2.1 Chassis cover
2.1.12.1.1
2.1.12.1.1
2.1.1
Removing the front coverRemoving the front cover
Removing the front coverRemoving the front cover
Removing the front cover
1. Use a Phillips screwdriver to remove
the screw on each front end of the
top cover.
1. Loosen the two thumbscrews on
the rear panel to release the top
cover from the chassis.
2. Firmly hold the tray level and pull
all the drive trays out of the bay.
2.1.22.1.2
2.1.22.1.2
2.1.2
Removing the rear coverRemoving the rear cover
Removing the rear coverRemoving the rear cover
Removing the rear cover
3. Then push the front cover as arrow
show.
4. Pull up the front cover, then
disconnect all the cables in the
front cover.
Finally leave the cover as side.
ThumbscrewsThumbscrews
ThumbscrewsThumbscrews
Thumbscrews