Filter
Top Products
Chapter 2: Hardware setup2-2
2.1 Chassis cover
The chassis features a “screwless design” that allows convenient assembly
and disassembly. You can simply push or slide mechanical bolts and locks to
remove the cover.
2.1.1 Removing the side cover
1. Remove the two screws that
secure the cover to the chassis.
2. Slide the side cover for about half
an inch toward the rear until it is
disengaged from the chassis.
3. Carefully lift the cover and set it
aside.
Viewing the internal structure
Without the side cover, the internal structure and installed components of
the barebone server vary depending on the model you purchased. Refer to
section “1.5 Internal features” for the different model congurations.
Perform the procedures in the succeeding sections to install the CPU, sys-
tem memory, disk drives, and expansion cards; replace fans and power sup-
ply; and connect the system cables.
2
1
1