Filter
Top Products
Chapter 2: Hardware setup2-44
To reinstall the front I/O board:
1. Place the I/O board in the bracket,
component side up. Secure the
front I/O board to the bracket
with a screw.
2. Position the I/O board into the bay
with the component side to the
left (close to the HDDs). Connect
the I/O cables to the connectors
on the back of the I/O board.
3. Insert the I/O board into the bay
until the bracket fits the front
edge of the bay.
4. Secure the I/O board bracket with
a screw.
USB 2.0 connector