Filter
Top Products
Chapter 2. Hardware Setup
9
PC Installation
Refer to the Installation Diagram on p. 10 (the numbers in the diagram
correspond to the numbers of the steps), as you do the following:
1. For each server or serial device, plug an RJ45 to Serial adapter into its
serial port. (See RJ-45 to Serial Adapters, page 78, for details on choosing
the appropriate adapter.)
Note: RJ-45 to Serial adapters require a separate purchase. To purchase
RJ-45 to Serial adapters, contact your dealer.
2. Use standard Ethernet cable to connect any available port on the SN0108 /
SN0116's rear panel to the adapter.
3. If you choose to install a serial modem for OOB operation (see Chapter 6),
use standard Ethernet cable to connect any available port on the SN0108 /
SN0116's rear panel to a DTE to DCE serial adapter (see RJ-45 to Serial
Adapters, page 78 for details on choosing the appropriate adapter), then
plug the adapter into the modem's serial port.
Note: This step is optional.
4. Plug the cable that connects the SN0108 / SN0116 to the network or the
Internet into its LAN port.
5. Use the AC power cord provided with this package to connect the SN0108
/ SN0116's Power Socket to an AC power source.
After you connect all the cables, you can turn on the SN0108 / SN0116.
sn816_Book-v2.book Page 9 Thursday, July 6, 2006 5:41 PM