Filter
Top Products
SN0108 / SN0106 User Manual
74
Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted, or you have forgotten it, for
example), you can clear the login information with the following procedure:
1. Power off the SN0108 / SN0106 and remove its housing.
2. Short the jumper labeled J6.
3. Power on the switch.
4. When the Link and 10/100Mbps LEDs flash, power off the switch.
5. Remove the jumper cap from J6.
6. Close the housing and start the SN0108 / SN0106 back up.
After you start back up, you can use the default Username and Password
(see Logging In, page 13) to log in.
sn816_Book-v2.book Page 74 Thursday, July 6, 2006 5:41 PM