Filter
Top Products
SN0108 / SN0116 User Manual
52
Indirect HyperTerminal Connection
This method uses HyperTerminal to phone into the SN0108 / SN0116 from a
remote location.
Setup:
1. Set up your hardware configuration to match the diagram, below
:
On the remote computer side, use a standard 9 pin serial modem cable
(pin 2 to pin 2; pin 3 to pin 3) to connect the computer to the modem.
On the SN0108 / SN0116 side, use Cat 5 cable and an RJ-45 to Serial
adapter to connect a modem to any of its serial ports (see the PC
Installation Diagram:, page 10). Also see RJ-45 to Serial Adapters,
page 78, for details on choosing the appropriate adapter. The usual
choice for connecting to a modem is SA0142.
Note: Be sure that the port you specify as the Console Port in the OOBC
dialog box (see p. 22) matches the port that you connect the modem
to. Change the setting, if necessary.
2. Create a HyperTerminal connection.
a) Start with Step 2 of the Direct HyperTerminal Setup section (p. 47).
b) For Connect using: in Step 4, select the type of modem connected to
your computer from the list. If your modem doesn't appear in the list,
select Standard 28800bps Modem.
c) Follow Steps 5-9 to complete the setup and create the connection icon.
Remote
Operator
Modem Modem
Phone Line
SN0108 / SN0116
Serial Modem Cable
Ethernet Cable
DTE to DCE
Adapter
sn816_Book-v2.book Page 52 Thursday, July 6, 2006 5:41 PM