Filter
Top Products
Setting Up - NetWare
38 AXIS 540+/AXIS 560
Section 2Setting Up - NetWare
This section describes how to continue the installation of the AXIS 540+/AXIS
560 in the NetWare environment. Identify which transport protocol you are
running on your network and which installation method you should use.
Continue the installation by selecting the appropriate installing instructions
from the table below:
See “NetWare Administration” on page 64. for information on Novell’s
administration tools.
If you intend to operate your AXIS 540+/AXIS 560 in a multi-protocol, mixed
environment, you should also proceed to the other relevant sections in this
manual.
Installation
method
Transport
protocol
Action
NDPS TCP/IP
IPX/SPX
See “Setup using NDPS” on page 39.
- Public Access Printers, on page 40
- Controlled Access Printers, on page 44
iPrint iPrint over LPR See “Setup using iPrint” on page 53.and
See “Install a printer using AXIS LPR Gateway Configuration
Snapin” on page 55.
iPrint over IPP See “Setup using iPrint” on page 53.and
See “Install a printer with AXIS IPP Gateway Configuration
Snapin” on page 55.
Queue-based
printing
IPX/SPX
Basic
Configuration
To install using the AXIS NetPilot Installation Wizard,
See “Basic Setup with AXIS NetPilot” on page 58..
IPX/SPX
Advanced
configuration
If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard,
See “Advanced Installation using AXIS NetPilot” on page 60..