Filter
Top Products
4. Getting Started
ON
OFF
Lamp 1
Lamp 2
Runtime(hrs)
Lamp Status
X(Lamp Take Over)
X-30 (WARNING)
2X-30 (WARNING)
2X (ALERT)
ON
OFF
Lamp 1 +Lamp 2
Runtime(hrs)
Lamp Status
X-30 (WARNING)
X (ALERT)
A
B
Image 4-4
Lamp runtime management
A Single lamp mode
B Dual lamp mode
x Maximum lamp runtime
In single mode, a lamp switch will be executed as far as the second
lamp has not reached its maximum runtime.
WARNING: Using a lamp for more than x hours is dangerous a
s the lamp could explode.
The lamp runtime reset as well as the lamp replacement can only be done by a Barco authorized technician.
4.4 Switching to standby
Howtoswitchtostandby?
1. Press Standby to switch the projector to standby.
Switching to Standby. When the projector is running and you want to go to standby, press the standby key for
2 seconds until the message ’Saving data, please wait’ is displayed. Do not press any longer on the standby
key otherwise the projector will restart.
4.5 Switching off
How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans stop blowing, at least 15 min.
3. Switch off the projector with the power switch.
4.6 Temperature error DMD
Overview
When the temperature of one of the DMD is too low or too high the projector will be switched automatically to standby. Before
switching to standby, the foll
owing message appears for 3 seconds on the screen : ’DMD out of operating temperature range.
Automatic shutdown is activated.’.
R5976629 BARCORLM G5 02/06/2006
37