Filter
Top Products
3. Connections
3. CONNECTIONS
Overview
• Power connections
• Switching on
• Switching to standby
• Switching off
• Input source connection
• Communications connections
3.1 Power connections
AC Power cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front of the projector. The power input is auto-ranging from 90 to 240 VAC.
Fuses
For continued protection against fire hazard :
• refer replacement to qualified service personnel.
• ask to replace with the same type of fuse (T10 AH/250V).
3.2 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
- When ’0’ is visible, the projector is switched off.
- When ’1’ is visible, the projector is switched on
The projector starts in standby mode. The projector mode indication lamp is red.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green (image 3-1, image 3-2)
Projector mode indication
Image 3-1
R5976493 BARCOREALITY SIM 6 MK II 08092003 13