6. Installation Mode
6.9.2 Defining the communication protocol of the RCVDS05
Which protocols are available?
When a RCVDS05 is connected to the projector, the type of communication protocol used to communicate with the peripheral has
to be defined in the 800 peripheral menu.
•PPM
• RC5
Defining the communication protocol
To define the communication protocol:
1. Push the cursor key ↑ or ↓ to highlight 800 Peripheral. (menu 6-19)
2. Press ENTER to select.
3. Push the cursor key ↑ or ↓ to highlight infrared. (menu 6-20)
4. Press ENTER to select.
5. Press ENTER to toggle between [PPM] or [RC5].
INSTALLATION
INPUT SLOTS
NO SIGNAL
LENS
MENU POSITION[CENTER]
QUICK ACCESS KEYS
800 PERIPHERAL
MORE ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-19
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-20
6.10 Configuration
What can be done ?
The way of physical installation of the projector can be defined to the projector.
The following installation configurations are possible:
• front/table
• front/ceiling
• rear/table
• rear/ceiling
Choosing the right configuration
1. Push the cursor key ↑ or ↓ to highlight Configuration. (menu 6-21)
2. Press ENTER to select.
The configuration menu will be displayed.
INSTALLATION
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
SHUTTER
ACTIVE 3D CONF.
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-21
R5976493 BARCOREALITY SIM 6 MK II 08092003 69