Filter
Top Products
4. Getting started
14 TEXT
when adjusting one of the image, e.g. controls during a meeting, the displayed bar scale
can be removed by pressing ’TEXT’ key first. To re-display the bar scale on the screen,
press ’TEXT’ key again.
15 ENTER
to start up the adjustment mode or to confirm an adjustment or selection in the adjustment
mode.
16
Cursor keys to make menu selections when in the adjustment mode or to zoom/focus when the direct
access is active.
Comparison between the cursor keys and the use of the ’+’ and ’-’ keys on the local keypad
: RCU = local keypad
cursor key up = ’+’ key up
cursor key down = ’-’ key down
cursor key right = ’+’ key right
cursor key left = ’-’ key left
17 EXIT to leave the adjustment mode or to scroll upwards when in the adjustment mode.
18
RC operation indication lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
Table 4-1
4.3 Operating the projector
4.3.1 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
- When ’0’ is visible, the projector is switched off.
- When ’1’ is visible, the projector is switched on
The projector starts in standby mode. The projector indication lamp is red.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green (image 4-2, image 4-3)
Projector mode indication
Image 4-2
R5976493 BARCOREALITY SIM 6 MK II 08092003 23