Barco RLM-W8 Projector User Manual


  Open as PDF
of 62
 
52
CONTROL
IR Address
Usethisfunctiontoconguretheprojector’sIRcodereceivecommandsfromtheremote
control.Thedefaultvalueis1.Ifyouhaveotherequipmentinyourhomethatcouldpickup
thecommandfromtheprojector’sremotecontrol,itisrecommendedthatyousettheremote
controlcodeto2.
Whenyouarerunningtwoprojectorsviaserialconnection,youcansetthecodeonone
projectoras“1”and“2”fortheotherprojector.Bydoingso,youwillbeabletocontroltwo
projectorswiththesameremotecontrol.
Whenyouwanttoswitchyourremotecontrolfromcode1projectortocode2projector,
pressandholdtheENTERandADDRESSbuttonsontheremotecontrolsimultaneously(for
approximately5seconds);thebacklightmoduleontheremotecontrolwillblinktoconrmthe
switch.
Eco Network Power
TheprojectorcanbeconnectedtoanetworkviaitsRS-232portand10/100BASE-Tport
forremoteoperationwithtwoseparateboardstocontrolthesignalsourcesfromRS-232and
10/100BASE-Tports.
Ifyoudonotrequireremoteoperationoftheprojectoroveranetwork,itisrecommendedthat
yousetthisfunctiontoOntoactivatetheECONetworkPower.Thiswillturnoffthepower
thatisusedtocontrolthe10/100BASE-Tboard.However,youwillnotbeabletooperatethe
projectorremotelyoveranetworkaslongasthefunctionremainsactivated.
BysettingittoOff,thefunctionwillbedisabled.Youwon’tbeabletoconservepowerbutyou
cancontroltheprojectorremotelyoveranetwork.
6
OSD Menu description
 previous next