Filter
Top Products
61
ISP setting in WAN site:
Obtain an IP Address automatically (DHCP Client)
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
End IP Address: 192.168.1.199
3.5.1 User Name and Password
The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your BiGuard
50G to its factory settings by holding the Reset button on the back of your router
until the Status LED begins to blink. Please note that doing this will also erase any
previous router settings that you have made. The Status LED will remain solid as the
device boots. Once the boot sequence is complete, the LED will shut off, indicating
that BiGuard 50G is ready.
3.5.2 LAN and WAN Port Addresses
The default values for LAN and WAN ports are shown below:
LAN Port WAN Port
IP address 192.168.1.254
Subnet
Mask
255.255.255.0
DHCP server
function
Enabled
IP
addresses
for
distribution
to PCs
100 IP addresses
continuing from
192.168.1.100
through
192.168.1.199
The DHCP Client is enabled
to automatically get the
WAN port configuration
from the ISP.