Filter
Top Products
16 Bradyprinter 200M-e and 200M-e 300 User’s Guide
&RQILJXULQJWKH6RIWZDUHRU3ULQWHU'ULYHU
Many printer settings may also be controlled by your printer’s driver or
label preparation software. Please refer to the driver or software
documentation for more information.
Table 1
Press Display Shows Action/Explanation
— PRINTER READY Normal printer operation.
DARKNESS
Press the (+) or (–) keys to increase or decrease the print
darkness setting. (You may need to change this setting when you
print your label.)
PRINT MODE
Press the (+) or (–) keys to select tear-off, peel-off, cutter, or
rewind mode.
MEDIA TYPE
Press the (+) or (–) keys to select continuous or non-continuous
media type. (If you choose continuous media, you must also
include a label length instruction in your label format.)
SENSOR TYPE
Press the (+) or (–) keys to select transmissive or black mark
sensing mode. Unless your media has black marks on the back,
leave your printer at the default setting (web).
PRINT METHOD
Press the (+) or (–) keys to select thermal transfer (if you are using
ribbon) or direct thermal (no ribbon).
MAXIMUM LENGTH
Press the (+) or (–) keys to set the value that is closest to, but not
less than, the length of the label you are using.
SAVE SETTINGS
Press the (+) or (–) keys to select:
PERMANENT — saves changes when the power is turned off.
Press SETUP/EXIT to accept the selection.
— PRINTER READY You have exited the configuration mode and are now ready to
calibrate the printer.