Brady 200M-e 300 Printer User Manual


  Open as PDF
of 118
 
Bradyprinter 200M-e and 200M-e 300 User’s Guide 17
0HGLDDQG5LEERQ&DOLEUDWLRQ
NOTE: All steps must be performed in the following procedure,
even if only one sensor needs to be adjusted.
1. Press the SETUP/EXIT key.
2. Press the NEXT/SAVE key until “MEDIA AND RIBBON
CALIBRATE” displays.
3. To start the calibration procedure, press the (+) key. “LOAD
BACKING CANCEL CONTINUE” displays.
4. Open the printhead. Remove approximately 8" (203 mm) of labels
from the media roll, enough so that only the backing material is
threaded between the media sensors when the media is loaded
(refer to Figure 10).
Figure 10
 previous next