Filter
Top Products
Bradyprinter 200M-e and 200M-e 300 User’s Guide 81
FEED Key and PAUSE Key Self Test
1. Turn off the printer.
2. Press and hold the FEED and PAUSE keys while turning on the power.
Performing this self test temporarily resets the printer configuration to the
factory default values. These values are active only until power is turned
off unless you save them permanently in memory.
Communications Diagnostics Test
This test is controlled from the front panel display. Refer to page 54. A
typical printout from this test is shown in Figure 34. Turn off the power to
exit this self test.
NOTE: This label is inverted when printed.
Additional Printer Diagnostics
Additional diagnostic tests are available for this printer, however, they are
beyond the scope of this user’s guide. Refer to the maintenance manual
for information about these additional tests.
Figure 34