Filter
Top Products
86 Bradyprinter 200M-e and 200M-e 300 User’s Guide
3ULQWLQJ6SHFLILFDWLRQV
* Media registration and minimum label length are affected by media type and width, ribbon type, and print
speed. Performance improves as these factors are optimized. Brady recommends always qualifying any
application with thorough testing.
5LEERQ6SHFLILFDWLRQV
Printing Specifications 200M-e/200M-e 300
Re so l ut io n 20 3 d ot s /i nc h ( 8 d ot s /m m) /
300 dots/inch (12 dots/mm)
D ot si ze (w idt h x l en gt h ) 0. 00 49 " x 0 .0 04 9" ( 0. 125 x 0 .1 25 mm) /
0.0033" x 0.0039" (0.84 mm x 0.10 mm)
First dot location measured from inside media edge 0.10" ± 0.035" (2.5 mm ± 0.89 mm)
Maximum print width 4.09" (104 mm)
Print Length
(maximum)
Continuous printing
(with standard 4 MB
memory)
203 dpi 90" (2337 mm)
300 dpi 41" (1041 mm)
Media registration toleration*
(non-continuous media)
Vertical = ≤ ±0.050" (1.3 mm)
Horizontal = ≤ ±0.050" (1.3 mm)
Programmable print speeds
203 dp i 2.0" (51 mm) thro ug h 8 .0" ( 20 3 mm)
per second in 1” increments
300 dp i 2.0" (51 mm) thro ug h 8 .0" ( 20 3 mm)
per second in 1" increments
Bar code modulus
(“X”) dimension
Ladder (rotated)
orientation
203 dpi 4.9 mil to 49 mil
300 dpi 3.9 mil to 39 mil
Picket fence (non-
rotated) orientation
203 dpi 4.9 mil to 49 mil
300 dpi 3.9 mil to 39 mil
Thin film printhead with Element Energy Equalizer (E
3
)
®
Yes
Ribbon Specifications 200M-e/200M-e 300
Ribbon must be wound with the coated side out.
Ribbon width (Brady recommends using ribbon at least as
wide as the media to protect the printhead from wear.)
Minimum 0.79" (20 mm)
Maximum 4.1" (104 mm)
Standard lengths
2:1 media to ribbon roll ratio 984 ft. (300 m)
3:1 media to ribbon roll ratio 1476 ft. (450 m)
Ribbon core inside diameter 1.0" (25.4 mm)
Maximum ribbon roll outside diameter 3.2" (81.3 mm)