Brady 200M-e 300 Printer User Manual


  Open as PDF
of 118
 
74 Bradyprinter 200M-e and 200M-e 300 User’s Guide
3ULQW4XDOLW\3UREOHPV
*HQHUDO3ULQW4XDOLW\,VVXHV
*UD\OLQHVRQEODQNODEHOVZLWKQRFRQVLVWHQWSDWWHUQ
/LJKWFRQVLVWHQWYHUWLFDOOLQHVUXQQLQJWKURXJKDOORIWKHODEHOV
,QWHUPLWWHQWFUHDVHVRQWKHOHIWDQGULJKWHGJHVRIWKHODEHOV
Problem Solution
You are using an incorrect media and ribbon
combination for your application.
Consult your authorized Brady distributor for information
and advice.
The printer is set at the incorrect print speed. For optimal print quality, set the print speed to the lowest
possible setting via ZPL II, the driver, or the software.
The printer is set at the incorrect darkness
level.
For optimal print quality, set the darkness to the lowest
possible setting via the front panel, the driver, or the
software.
The printhead is dirty. Clean the printhead according to the instructions on
page 64.
There is light printing (or no printing) on the
left or right side of the label or the printed
image is not sharp.
The toggle pressure needs to be adjusted. Follow the
printhead pressure adjustment instructions on page 70.
Problem Solution
The printhead is dirty. Clean the printhead according to the instructions on
page 64.
Problem Solution
The printhead or platen roller is dirty. Clean the printhead, platen roller, or both according to the
instructions on page 64.
Problem Solution
There is too much toggle pressure on the
printhead.
Reduce the toggle pressure. See “Printhead Pressure
Adjustment” on page 70.
 previous next