Filter
Top Products
Should it become necessary to ship your printer, remove any
ribbon and paper roll from the supply spools, otherwise damage
to the printer could result. Carefully pack the printer in a suitable
container to avoid damage during transit. Whenever possible, use
the original container and packaging material from the factory. If
you use a different container, a procedure similar to the original
factory packaging should be followed.
CAUTION: Do not package the printer in a rigid container
without utilizing shock mounts or shock-absorbing packing
material. A rigid container will allow shock on the outside to
be transmitted undamped to the unit, which may cause damage.
The M-Series Printer’s AC voltage may be set for either
100-120 VAC or 220-240 VAC operation. To match the printer’s
power entry selection to the available power source, refer to
Figure 2.1 and follow the procedure outlined below:
1. Locate the AC power area at the rear of the printer.
2. Using a small flatblade screwdriver or similar tool, move the
Voltage Selection switch to the 100-120 V or 220-240 V posi-
tion as re-
quired. (The in-
itial position of
the switch de-
pends on how
the printer was
ordered.) Make
sure that the ap-
propriate fuse
is in place. See
Fig. 2.1.
2-2