Filter
Top Products
Proprietary Statement
This manual contains proprietary information of Brady USA, Inc. It is intended solely for the information and use
of parties operating and maintaining the equipment described herein. Such proprietary information may not
be used, reproduced, or disclosed to any other parties for any other purpose without the expressed written
permission of Brady USA, Inc.
Product Improvements
Continuous improvement of products is a policy of Brady USA, Inc. All specifications and signs are subject to change
without notice.
FCC Compliance Statement
Note: This equipment has been tested and found to comply with the limits for a Class A digital Device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
In order to insure compliance, this printer must be used with a Shielded Power Cord and Shielded Communication
Cables.
“The user is cautioned that any changes or modifications not expressly approved by Brady USA, Inc. could void the user’s
authority to operate the equipment.”
Canadian DOC Compliance Statement
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in
the radio interference regulations of the Canadian Department of Communications.
Liability Disclaimer
Brady USA, Inc. takes steps to assure that its published Engineering specifications and Manuals are correct; however,
errors do occur. Brady USA, Inc. has been advised of the possibility of such damages. Because some states do not
allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply
to you.
Copyrights
The copyrights in this manual and the label printer described therein are licensed to Brady USA, Inc. All rights are
reserved. Unauthorized reproduction of this manual or the software in the label printer may result in imprisonment of
up to one year and fines of up to $10,000 (17 U.S.C.506). Copyright violators may be subject to civil liability.
ZPL II
®
and E
3®
are registered trademarks of Zebra Technologies Corporation
Centronics
is a registered trademark of Genicom Corporation
IBM
is a registered trademark of IBM Corporation
© Zebra Technologies Corporation, portions © Brady USA, Inc.