Filter
Top Products
Wrinkled ribbon. Ribbon fed through
machine incorrectly.
See Ribbon Loading in the
Operation Section.
Incorrect Darkness
setting.
Set to the lowest value needed
for good print quality.
Incorrect printhead
position or pressure.
Adjust Toggle Pressure and/or
position.
Media not feeding
properly; it is walking
from side to side.
Make sure the media is snug by
adjusting the media guides.
Continuing symptoms. Call a service technician.
Continued wrinkled
ribbon.
Strip plate needs
adjusting.
Call a service technician.
Misregistration and
misprint of 1 to 3 labels.
Media was pulled when
motor was not moving.
Enter Calibrate Mode and
recalibrate.
Incorrect Media Sensor
position.
See Media Sensor Position in
the Adjustments Section.
Media or ribbon
improperly loaded.
See Media and Ribbon Loading
procedures in Installation Section.
Incorrect Media Sensor
Position or Sensitivity.
See Configuration and
Calibration Section.
Changes in parameter
settings did not take
effect.
Parameters are set or
saved incorrectly.
Reload the factory defaults.
Refer to the Operation Section
and Calibrate the printer. Then,
cycle the Power ON/OFF Switch.
If problem continues,
there may be a problem
on the Main Logic
Board.
Call a service technician.
8-4