Filter
Top Products
This section contains Preventive Maintenance information for the
Brady M-Series Printer. These procedures may be performed by
the operator.
The exterior surfaces of the printer may be cleaned as required by
using a lint free cloth. Do not use harsh or abrasive cleaning
agents or solvents. If necessary, a mild detergent solution or
desktop cleaner may be used sparingly.
Remove any accumulated dirt/lint from the interior of the printer
using a soft bristle brush and/or vacuum cleaner. This area should
be inspected after every four rolls of media.
The cleaning supplies are found in the Printer Cleaning Kit (PCK-2).
Printhead Alcohol After every roll of
media (or 500 ft. of
fanfold media) when
printing direct thermal
or after every roll of
ribbon when printing in
thermal transfer mode.
Platen Roller Alcohol
Upper and Lower
Media Sensors
Air Blow
Media Path Alcohol
Ribbon Sensor Air Blow
Peel/Tear Bar Alcohol As needed.
Label Available Sensor Air Blow Monthly.
6-1