Filter
Top Products
This procedure sets the darkness of the printing on the label. Use
the lowest setting which provides the necessary print quality.
1. Press the MODE key. PAUSE and DARKEN lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key 3 times. The MODE lights will flash ON
and OFF to indicate that the settings have been saved in mem-
ory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
This procedure sets the end-of-label position relative to the
Tear-Off Bar or Cutter.
1. Press the MODE key twice briefly. PAUSE and POSITION
lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will
flash ON and OFF to indicate that the settings have been
saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
This procedure positions the printing on the label relative to the
top edge of the label.
1. Press the MODE twice briefly then press and hold for about 5
seconds until the lights change. PAUSE and DARKEN and
CALIBRATE lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will
flash ON and OFF to indicate that the settings have been
saved in memory.
Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
4-6