Filter
Top Products
Printer stops. PAUSE light
and PAPER/RIBBON light
both ON.
Media incorrectly
loaded or not loaded.
Load media correctly. See
Media Loading in Installation
Section.
Misadjusted Media
Sensor.
Media not Calibrated.
Check Position and Sensitivity
of Media Sensor and/or
Calibrate Media. See
Adjustments in Configuration
and Calibration Section.
Printer stops. PAUSE
light ON and PAPER/
RIBBON light
FLASHING.
Ribbon incorrectly
loaded or not loaded.
Load ribbon correctly. See Ribbon
Loading in Installation Section.
Malfunctioning Ribbon
Sensor.
Call a service technician.
Printer stops. PAUSE light
ON and PRINTHEAD light
FLASHING.
Printhead is not fully
closed.
Close printhead completely.
Printhead Open Sensor not
detecting its position flag.
Call a service technician.
Printer stops. PAUSE light and
PRINTHEAD light both ON.
Printhead element is
overheated. (200M or
260M)
Printer resumes printing when the
printhead element cools. If
condition persists, move printer to a
cooler environment.
On the 260M only,the
power supply is
overheated.
Printer resumes printing when the
power supply cools. If condition
persists, move printer to a cooler
environment.
Dots missing in printed
area of label.
Printhead element going
bad.
Call a service technician.
Loss of printing
registration on labels.
For Peel-Off Mode.
Possible Media Sensor
or Calibration problem.
Adjust Media Sensor Position
or Calibrate Media. Call a
service technician if
necessary.
Printer set for non-
continuous media, but
continuous media loaded.
Set printer for correct media.
See Installation Section.
Improperly adjusted
Media Edge Guides.
Refer to Installation Section.
Excessive vertical drift in
top-of-form registration.
Incorrect media
loading.
See Media Loading in the
Installation Section.
8-2