Filter
Top Products
8-13 Confidential
DCP7010/7020/7025
(1) Press the
key or key several times to display the “MAINTENANCE 10” code on the
LCD. Then press the Set key.
The machine displays the "WSW00" on the LCD and becomes ready to accept a
firmware switch number.
(2) Press the
key or key to display the firmware switch which is desired to be changed
on the LCD. Then press the Set key .
The following appears on the LCD:
Selector 1 Selector 8
↓ ↓
WSWXX = 0 0 0 0 0 0 0 0
(3) Enter “1” by pressing the
key. Enter “0” by pressing the key. The cursor will be
shifted to the right by one position. Repeat this operation to modify the Selector from
Selector 1 to Selector 8.
(4) Press the Set key. This operation saves the newly entered selector values onto the
EEPROM and readies the machine for accepting a firmware switch number.
(5) Repeat steps (2) through (5) until the modification for the desired firmware switches is
completed.
(6) Press the Stop/Exit key to return the machine to the initial stage of the maintenance
mode.
NOTES: • To cancel this operation and return the machine to the initial stage of the maintenance
mode during the above procedure, press the Stop/Exit key.
• If there is a pause of more than one minute after a single-digit number is entered for
double-digit firmware switch numbers, the machine will automatically return to the
initial stage of the maintenance mode.
Details of Firmware Switches
• The details of the firmware switches are described in Appendix 4 in which the user-
accessible selectors of the firmware switches are shaded.
• Machine w/o fax support some selectors of firmware switches. Those selector numbers
are circled.