Filter
Top Products
SETUP RECEIVE
5 - 4
Setting the Print Density
If your MFC is printing too light or too dark, you can adjust print density,
making your printed documents darker or lighter. The new setting will remain
until you change it again.
1
Press Menu/Set, 2, 1, 5.
2
Press to make print darker or to
make print lighter, and then press
Menu/Set.
3
Press Stop/Exit.
Advanced Receiving Operations
Operation from Extension Telephone
If you answer a fax call on an extension phone or on an external phone in the
EXT. jack, you can make your MFC take over by using the Fax Receive Code.
When you press the Fax Receive Code 5 1, the MFC starts to receive a fax.
(See
Easy Receive, page 5-3.)
If you answer a call at an extension or external phone, and no one is on the line,
assume you’re receiving a fax. At an extension phone, press 5 1, wait for fax
receiving tones (chirps), then hang up. At an external phone, press 5 1 and
wait for the phone to be disconnected (the LCD shows RECEIVING) before
you hang up. (Your caller will have to press Fax Start to send the fax.)
Changing the Fax Receive Code
The preset Fax Receive Code ( 5 1) might not work with some telephone
systems.
1
Press Menu/Set, 2, 1, 3.
2
Press to select ON (or OFF),
and then press Menu/Set.
3
If you want to, enter a new Fax Receive
Code, and then press Menu/Set.
4
Press Stop/Exit.
Note
If you are always disconnected when accessing your external TAD remotely,
try changing the Fax Receive Code from 5 1 to # # #.
5.PRINT DENSITY
3.REMOTE CODE
REMOTE ACT.:ON?
SELECT & SET
or
FAX RECEIVE:
*
51
ENTER & SET KEY