Filter
Top Products
9
SET UP
For a serial port connection:
B For Windows
®
NT4.0/2000 Professional/XP Professional/XP Home Edi-
tion users:
If a P-touch (PTCOM) port is not installed, add one by clicking the Add
button to display the Port Name dialog box.
If a P-touch (PTCOM) port is already installed, click the Next button and
continue with step 13.
From the list of PTCOM ports in the Port Name dialog box, select the
port where the SC-2000 is connected (“PTCOM1:” if the SC-2000 is
connected to the COM1 port, or “PTCOM2:” if the SC-2000 is con-
nected to the COM2 port), and then click the OK button to return to the
dialog box.
Then, click the Next button in the dialog box.
C A dialog box appears, allowing you to select the PTCOM port where
the SC-2000 is connected. Select “PTCOM1:” if the SC-2000 is con-
nected to the COM1 port, “PTCOM2:” if the SC-2000 is connected to
the COM2 port, or “LPT1:” if the SC-2000 is connected to the LPT1 port,
and then click the Next button. (On Windows
®
NT 4.0/2000 Profes-
sional/XP Professional/XP Home Edition, select the port added in step
12.)
D In the dialog box that appears, allowing you to confirm how the installa-
tion will be carried out, check that the installation will be carried out as
desired, and then click the Next button.
E A dialog box showing that the printer driver has been installed appears.
To check the connection between the SC-2000 and the computer, select
“Start up the Change Baud Rate Wizard”, ONLY THEN turn on the
SC-2000, and then click the Next button.
F The Change Baud Rate Wizard starts up. When asked to select the port
where the SC-2000 is connected, select the same port selected in step
13, and then click the Next button.
G Select the desired baud rate, and then click the Next button.
Normally “57600 bps” is selected; however, your computer may not be
able to support a baud rate of 57,600 bps. If this is the case, refer to your
computer's instruction manual and select the maximum possible baud
rate.