Filter
Top Products
6
SET UP
Connecting the Interface and Power
Supply Cables
After connecting the interface and power supply cables to the SC-2000, it can be used to create stamps from any layout that
you design in the Stampcreator P-touch Editor software or Stampcreator Express software installed on your computer.
1 Be sure both the SC-2000 and the computer are turned off.
2 Attach the appropriate interface cable connector to the computer port.
☞ NOTE: After connecting the 9- or 25-pin connector, be sure to tighten the screws to
lock it into place.
3 Connect the other end of the interface cable to the interface jack on the back of the SC-2000.
☞ NOTE: After connecting the interface cable to the 36-pin connector jack on the
SC-2000, be sure to squeeze the wire clips against the connector until they lock
into place.
4 Insert one end of the power supply cord into the power supply jack on the SC-2000 and the other end of the cord into
an AC outlet.
36-pin connector
8-pin connector
Back:
36-pin connector jack
25-pin connector
9-pin connector
25-pin connector
8-pin connector jack
Power supply jack
Power switch