Filter
Top Products
10
SET UP
H When the “Are the following settings OK?” dialog box appears, check
that the baud rate will be changed as desired, and then click the Next
button.
To change the setting, click the Back button, and make the necessary
changes.
I Using the buttons on the SC-2000, change its baud rate to the baud rate
selected in step 17.
Then, click the Next button in the “PC settings were changed.” dialog
box. A test transmission is sent to check that the settings of both the
computer and the SC-2000 are the same.
☞ NOTE: The default baud rate of the SC-2000 is
57,600 bps. If the baud rate of the COM port
is changed, be sure to follow the procedure
described below to change the baud rate of
the SC-2000.
(a) Press the Mode button on the SC-2000 four times until “BAUD RATE”
appears, and then press the Set button.
(b) The currently selected baud rate appears. Press the Mode button
until the baud rate selected with the Change Baud Rate Wizard ap-
pears.
(c) Press the Set button.
J When the “The settings are changed.” dialog box appears, showing that
the baud rate has been set as specified, click the Finish button.
K When the “Driver setup is completed” dialog box appears, click the
Finish button to exit Driver Setup.
L After the Setup Status window appears, the InstallShield Wizard Com-
plete dialog box appears.
M Remove the CD-ROM from the computer.
In the InstallShield Wizard Complete dialog box select “Yes, I want to
restart my computer now.” and then click the Finish button to complete
the setup and to restart the computer.
This completes the installation of the Stampcreator P-touch Editor soft-
ware and the printer driver for a serial port connection.