Filter
Top Products
DESIGINING A STAMP
47
MAKING A STAMP
3458
Making an ID label
After engraving the stamp, we can print the same layout on a label that can
be attached to the stamp for easy identification. In order to see how the
stamp will appear when it is engraved, the ID label can be printed before
engraving the stamp.
1 Insert an ID label sheet, so that the words “ID LABEL” can be read,
straight into the narrow ID label slot to the right of the draft tray slot.
☞ NOTE: Be careful not to touch the print area of the
ID label sheet since dust, fingerprints, hand
creams, etc. may prevent the characters
from being printed correctly.
Be sure that the ID label is the correct size.
Do not use an ID label that has been folded.
• ID labels for smaller size stamps (1212, 2020, 3030, 4040, 1060,
and 1438) have two printing areas on each label. Print labels in the
lower portion first, and then save the unused portion for future use.
The machine will always print on the lower portion.
2 With the layout of the engraved stamp displayed in Stampcreator P-
touch Editor, select the Print command in the File menu.
Or click
in the Print Properties. The Print dialog box appears.
3 Select “ID Label”, and then select the appropriate setting in the “Docu-
ment Type” drop-down list.
Insert an ID label sheet into the ID label slot of the SC-2000, and then
click the Print button to start printing the ID label.
☞ NOTE: For details on printing an ID label with
Stampcreator Express, refer to page 39.
• The ID label will automatically be fed from the slot on the top at the right
end of the machine.
Applying an ID label
After the label has been printed and fed from the exit slot on the top at the
right end of the SC-2000, remove it, peel off the ID label from its backing
paper, and then affix the ID label to the top of the grip.
☞ NOTE: Some stamps, such as the 4090, 3458, and
4040, have an L-shaped ID label. When
attaching this type of ID label, apply the
short side first, and then apply the remaining
side to the stamp grip.
ID label slot
Grip
ID label