Filter
Top Products
DESIGINING A STAMP
45
MAKING A STAMP
Mode Set
5 Insert a stamp between the doors so that the teeth in the center of the
doors fit into the notches in the center of the stamp (see figure 5).
Make sure that the stamp surface lies flat on the printed draft sheet.
☞ NOTE: Do not use a stamp that has the protective
film removed from the stamp surface or that
has been assembled with the skirt and grip.
Before inserting the stamp, be sure that
there is no dust on the protective film
covering its surface.
Be sure that the stamp is at the same
temperature as the SC-2000, otherwise the
stamp may not be engraved correctly.
Be careful not to break the ink bag inside the
stamp.
6 Slowly close the doors. Close the stamp compartment cover to the lock
position in order for the xenon lamp to flash (see figure 6).
☞ NOTE: Do not look directly at the light.
• The message “REMOVE STAMP” appears in the LCD. Open the doors in
the stamp compartment to remove the stamp (see figure 7).
• The draft sheet will automatically be fed from the slot on the top at the
right end of the machine.
☞ NOTE: Bright light! Do not open the stamp
compartment cover until the xenon lamp has
finished flashing.
figure 5
figure 6
figure 7