Filter
Top Products
16
SET UP
First Steps
After you have designed a stamp layout using the Stampcreator P-touch Editor software or Stampcreator Express software,
you can engrave it into a stamp.
Installing the ink ribbon cassette
1 Press the ink ribbon compartment cover button to open the cover.
☞ NOTE: Open and close the ink ribbon compartment
cover by pressing only on the position
specified.
2 If the ink ribbon in the cassette is loose, turn it over and use your finger
to wind the toothed wheel on the large knob on the right side until there
is no slack in the ribbon.
3 Insert the knobs on the left end of the cassette into the slots on the left
side of the compartment, and then push down on the right end of the
cassette so that the knobs on the right side slide into the slots on the right
side of the compartment.
4 Slowly close the ink ribbon compartment cover so that it locks into place.
☞ NOTE: Be careful not to pinch your fingers with the
compartment cover while closing it.
Replacing a used ink ribbon cassette
1 Remove the empty cassette by pulling it straight up.
2 Follow the instructions described above to insert the new ink ribbon
cassette.
☞ NOTE: One ink ribbon cassette will yield
approximately150 stamps and ID labels. The
message “CHECK RIBBON” will appear on
the Stampcreator Pro’s LCD when the
cartridge is empty. To order more ink ribbon
cassettes, see page 59.
Slots
Ink ribbon
cassette
Ink ribbon compartment