Chapter 5: Local Management
5-58 2H23-50R/2H33-37R User’s Guide
Port Redirect operates at a switch interface level and not at a repeater port
level. If traffic is redirected to interfaces that include active repeater ports,
then the redirected traffic is transmitted out all of the repeater ports
connected to the interface.
To access the Port Redirect Function screen from the Device Specific
Configuration Menu screen, use the arrow keys to highlight the PORT
REDIRECT FUNCTION menu item and press ENTER. The Port
Redirect Function screen displays.
Figure 5-22 Port Redirect Function Screen
The following definitions briefly explain each field of the Port Redirect
Function screen:
Source Port (Read-only)
Shows which ports are currently set as source ports. To display the ports,
refer to Section 5.15.1.
Destination Port (Read-only)
Shows which ports are currently set as destination ports.
Firmware Revision: XX.XX.XX
Port Redirect Function
22861_22
BOOTPROM Revision: XX.XX.XX
Source Port:
1
1
1
2
2
3
3
3
Destination Port:
2
3
4
1
3
4
5
6
Device Type: 2H23-50R
Remap Errors:
ON
ON
ON
OFF
OFF
ON
ON
ON
============ ============ ============
2H23-50R LOCAL MANAGEMENT
Event Message Line
SAVE
PREVIOUS
RETURN
RETURN
NEXT
Source Port [1] Destination Port [1] Status [ADD]
EXIT
Errors [ON]